Rough Country 747.20 - Manual (Page 11)

12. On the driver side of the rear axle bolt the rear brake extension bracket to the axle using factory hardware and a
12mm wrench. Attach the factory bracket to the new extension bracket using the supplied 1/4” bolts, washers, and
locking nuts. Tighten with a 11mm socket and wrench. See Photo 5.
13. Bolt the two flat brake line brackets to the axle as shown in Photo 5 with factory hardware. Tighten with a 12mm
socket. Use the supplied 1/4” bolts, washers, and locking nuts to attach the brake line the new brackets. Tighten with
a 11mm socket and wrench.
14. Loosen the two bolts holding the carrier bearing and then remove one side using a 17mm socket. Slide 3 of the shim
plates between the frame and carrier bearing on one side. Insert the supplied 10mm x 50mm bolt and washer from
1746bag6 and hand tighten. Remove the factory bolt from the other side and slide 3 shim between the frame and
carrier bearing. Insert the other supplied 10mm x 50mm bolt and washer and tighten both bolts with a 17mm socket.
See Photo 6. The number of shim plate can be adjusted if the rear drive shaft has vibration during acceleration.
15. Reinstall wheels and tires using a 21mm deep well socket.
16. Lower vehicle to the ground.
PHOTO 5 PHOTO 6