Rough Country 202S - Manual (Page 8)

Thank you for choosing Rough Country for your suspension needs.
KIT CONTENT
Dr. upper
Control arm
Strut spacers
Pass. Upper
control arm
POST INSTALLATION INSTRUCITONS
1. Lightly grease the ball joints. Do not over grease the ball joint as this could cause ball joint boot failure.
2. Have a qualified alignment center align the vehicle immediately.
3. Have headlights adjusted to proper settings.
4. Wheels must be retightened at 50 miles.
5. All kit components must be retightened at 500 miles and then every three thousand miles after installation. Periodically
check hardware for tightness.
6. Install “Warning to Driver” decal on sun visor.
7. On some vehicles the front lower skirting will need to be trimmed if using certain wheel /tire combinations and with
heavy offset wheels. Trim only as needed.
202S Box Kit
1-Driver Side Control Arm
1-Pass Side Control Arm
2-Strut Spacers
1-Dr Side RR Shock Brkt
1-Pass Side RR Shock Brkt
2-Rear Spacers
2-Rear Spacer Retainers
2-Rear Sway Bar Links
1-Front Kit Bag:
For Lower Strut:
4-3/8” x 2 1/4 bolts
8-3/8” washers
4-3/8” lock nuts
For Upper Control Arms:
2-1/4” nut
2-1/4” Flat Washers
For Front Strut Spacers:
6-10mm Studs
6-10mm Lock Washers
6-10mm Flat Washers
6-10mm Nuts
1-Rear Kit Bag:
For Rear Coil Spacer:
2-3/8” x 3 3/4” Bolts
2-3/8” Flange Locknut
For Rear Brake Line:
1-Sleeve
1-8mm x 60mm Bolt
For Rear Sway Bar Link:
2-12mm x 65mm Bolt
2-12mm Flange Lock Nuts
2-Flat Washers
4-12mm ID Sleeves
For Rear Shock Relocation Brackets
2-14mm x 75mm Bolts
2-14mm Lock Nuts
2-Flat Washers
2-5/8” x 1 1/2’ Bolts
4-5/8” Flat Washers
2-5/8” Lock Nuts
Rear Shock Brackets
Rear Coil Spacers
Rear Coil Retainers
Rear Sway
Bar Link