Rough Country 202S - Manual (Page 6)

REAR INSTALLATION
1. Chock the front wheels.
2. Place a floor jack under the differential and jack up the rear of the vehicle.
3. Place jack stands under the frame rails and lower onto the jack stands.
4. Remove the tires/wheels.
5. Locate and remove the ABS wire from the frame.
See Photo 1.
6. Remove the upper and lower shock from the axle using a 21mm socket/ wrench.
See Photo 2.
7. Remove the upper sway bar link using a 18mm socket/ wrench.
See Photo 3.
8. Remove the e-brake mount mount using a13mm socket / wrench.
See Photo 4.
9. Remove the brake line with a 13mm wrench.
See Photo 5.
10. Remove the coil.
11. Install the spring spacer washer on top of the mount as shown in
Photo 6.
Photo 1 Photo 2
Photo 3 Photo 4
Photo 5 Photo 6