Rough Country 290.20 - Manual (Page 8)

22. Support diff. Using a 18mm socket and 21mm socket remove the bolts from diff. lower diff from truck.
See Photo 18.
23. Mark the front and rear sides of the driver ’s side rear control arm pocket, measure 3 3/8” and cut rear lower control arm
pocket.
See Photo 19.
24. Cut and remove the skid plate bracket from the front factory cross-member. Cut the corners out of both front lower con-
trol arm pockets.
See Photo 20.
25. Cut the upper control arm bump stop out as shown in
Photo 21.
26. Then measure 1 5/8 from the cam bolt pin down and mark both side of the front control arm pocket this is your cut line.
Cut straight back to frame then straight down against frame. Clean and paint all cut areas.
See Photo 22.
27. Using template on passenger side of truck mark and drill the hole to a 9/16. this hole is for the rack and pinion mount.
then on driver side using the template mark and cut the area using a 3 inch hole saw.
See Photo 23.
Photo 18 Photo 19
Photo 20 Photo 21
Photo 23 Photo 22