Rough Country 290.20 - Manual (Page 12)

42.Install CV axle using stock hardware and a 15mm socket to tighten.
43.Install brake line bracket using the supplied 3/8
” x 1” bolts, washers, and nuts. See Photo 42. Use a13mm wrench and
socket to tighten.
44.Press in the10mm studs into the strut spacer. Install strut spacer on to strut using stock hardware and a 18mm wrench to
tighten.
45.Install strut into truck using the supplied 10mm nuts and lock washers. Use a 17mm wrench to tighten.
See Photo 43.
Use stock hardware for lower strut mount and use a 15mm wrench to tighten lower strut bolts
46.Install knuckles using stock hardware.
See Photo 44. Use a 24mm for lower ball joint a 18mm for upper joint and a
35mm for axle nut. Install rotor and install bolt using a 30mm torx socket. Install the brake caliper using a 18mm socket
for the bolts.
47.Install stock brake line bracket to upper control arm using a 10mm socket. Install ABS wire onto the cam lock washers
and plug in.
See Photo 45. Install tie-rod using a 21mm and 10mm to tighten.
48.Install skid plates using supplied 3/8 ” x 1.25” bolts and
washers. First insert the stock two bolts for upper skid plate
and let the lower part hang. Install the bolts to the rear of
the lower skid plate first then push the lower skid into place
and overlap it with the front skid. The 3/8
” bolts will go
through both skids into the front crossmember.
See Photo
46. Use a 14mm and a 15 mm socket to tighten all bolts
49.Jack up the truck and remove the jack stands. Lower truck
on ground tighten upper and lower control arm bolts using
21mm for upper and 18mm and 24mm socket and wrench
for bottom.
Photo 42 Photo 43
Photo 44 Photo 45
Photo 46