Rough Country 1057 - Manual (Page 3)

8. Install the supplied 10mm x 35mm bolts as shown in the bracket and threaded hole in the uni-body. (Driver Side
Shown) Do not tighten until all bolts are installed in bracket. See Photo 7.
9. Install the supplied 7/16” x 1 1/4” bolts, washer and lock nuts as shown in Photo 8.
10. Proceed to pass side to install bracket.
11. Place the bracket on the uni-body and install the forward 7/16” x 4” bolt, washers & lock nuts, the 10mm x 35mm bolt
in threaded hole in uni-body and the two 7/16” x 1 1/4” bolts, washers and lock nuts. See Photo 9.
12. Drill the rear hole using a 15/32” drill bit and install the 7/16” x 4” bolts, washers and lock nut. See Photo 10.
13. Tighten the 7/16” hardware using a 9/16” socket/ wrench and the 10mm using a 17mm socket.
14. Install the winch plate in the bumper as shown with the supplied qty 8 (4 per side)1/2” x 1 1/2” bolts, washers and
lock nuts. Tighten with a 3/4” socket / wrench only after both sides of the winch plate has been installed in the
bumper. See Photo 11.
15. Install the bumper on the bumper brackets with the supplied qty 14 (7 per side) 1/2” - 1 1/2” bolts, washers and lock
nuts. See Photo 12. Tighten using a 3/4” socket / wrench.
16. Included in this kit are bolts and nuts to mount the optional stinger, light-bar and d-ring kits. If these kits are not pur-
chased with this bumper, the hardware can be installed to cover the accessory locations. If desired install the sup-
plied 1/2” x 1 1/2” button head bolts in the top of the winch bumper and the front of the winch bumper.
17. Also included in this kit are 2 12mm x 35mm bolts for the roller fairlead. Hardware included with some winches do
not supply hardware long enough to install through the plate and fairlead on this bumper. This can be installed dur-
ing the winch installation process, but preferably before the winch is installed to easily gain access to this hardware.
Photo 7 Photo 8
Photo 9 Photo 10
Photo 11 Photo 12
Install 12mm x 35mm Bolt Install 7/16” x 1 1/4” bolts / hardware
Install the 7/16” x 4” Bolt/ hardware Drill and install 7/16” x 4” hardware
Install 1/2” x 1 1/2” bolts / hardware Install 1/2” x 1 1/2” bolts / hardware