Rough Country 1057 User Manual
Page 2
INSTALLATION INSTRUCTIONS
1. Place vehicle on a flat surface and set emergency brake.
2. Remove the front bumper end caps as shown in Photo 1 & Photo 2 using a 10mm wrench and remove the cap from
the bumper.
3. Remove the bumper as shown in Photo 3 by removing the bolts using a T30 torx head bit wrench.
4. Remove the bumper bolts ( three per side) as shown in Photo 4 from the uni-body using a 15mm socket.
5. Remove the rear most bumper bolt from the uni-body using a T55 torx bit. See Photo 5.
6. Remove the bumper from the vehicle.
7. Install the bumper bracket on the frame as shown with the 7/16” x 4” bolts, washers and lock nuts on the driver side.
See Photo 6. Do not tighten until all bolts have been installed.
Photo 1
Photo 2
Photo 3
Photo 4
Photo 5
Photo 6
Remove bumper caps
Remove bumper caps
Remove bumper hardware
Remove bumper hardware
Remove bumper brackets
Install 7/16” x 4” bolts / hardware
- PERF689 (12 pages)
- 1308 (4 pages)
- 576.20 (16 pages)
- 1010 (4 pages)
- 787.22 (14 pages)
- 282 (14 pages)
- 1098 (1 page)
- 598S (17 pages)
- 379.22 (8 pages)
- 1051 (1 page)
- 392.24 (6 pages)
- 1109 (2 pages)
- 1011 (4 pages)
- 263.22 (9 pages)
- 7599 (4 pages)
- 1169 (2 pages)
- 87496 (4 pages)
- 288.20 (8 pages)
- 324S (20 pages)
- 283N2 (2 pages)
- PERF677 (8 pages)
- 699 (2 pages)
- 1305 (4 pages)
- 774S (10 pages)
- 1403 (2 pages)
- 9219 (2 pages)
- 1186 (1 page)
- 592.20 (8 pages)
- 1113 (2 pages)
- 563.20 (8 pages)
- 1054 (4 pages)
- 479.20 (8 pages)
- 87349 (2 pages)
- 280N2 (12 pages)
- 1021 (4 pages)
- RC0342 (2 pages)
- 3592 (2 pages)
- 1776 (1 page)
- 1182 (1 page)
- 1040 (2 pages)
- 561.20 (4 pages)
- 1117 (4 pages)
- 75113-15 (16 pages)
- PERF662X (8 pages)
- 1156 (2 pages)