Rough Country 1304 - Manual (Page 4)

15. Repeat steps 4-14 on opposite side of vehicle
16. Using a 15mm wrench, reinstall sway bar bushings and nut using factory hardware. Torque to factory specs. Plug
the three connectors back into the electric power steering.
17. Install the wheels / tires, using a 21mm deep well socket.
18. Jack up the vehicle and remove the jack stands. Lower the vehicle to the floor and torque all bolts to factory specifi-
cations.
19. Using an certified alignment professional, have an alignment done to factory specifications.
POST INSTALLATION
1. Check all fasteners for proper torque. Check to ensure there is adequate clearance between all rotating, mobile,
fixed and heated members. Check steering for interference and proper working order. Test brake system.
2. Perform steering sweep. The distance between the tire sidewall and the brake hose must be checked closely. Cycle
the steering from full turn to full turn to check for clearance. Failure to perform inspections may result in component
failure.
3. Re torque all fasteners after 500 miles. Visually inspect components and re torque fasteners during routine vehicle
service.
4. Readjust headlights to proper settings.
MAINTENANCE INFORMATION
It is the ultimate buyers responsibility to have all bolts/nuts checked for tightness after the first 500 miles and then every
1000 miles. Wheel alignment steering system, suspension and driveline systems must be inspected by a qualified pro-
fessional mechanic at least every 3000 miles.
KIT CONTENTS
Kit Contents:
2-Front Strut Extensions
1-Kit Bag that includes
4-10x1.5x80mm bolts
8-SAE Flat washers
4-10mm nuts
Thank you for purchasing a Rough Country Suspension System.