Rough Country 862 - Manual (Page 4)

Post Installation
1. Check all fasteners for proper torque. Check to ensure there is adequate clearance between all rotating, mobile,
fixed and heated members. Check steering for interference and proper working order. Test brake system.
2. Perform steering sweep. The distance between the tire sidewall and the brake hose must be checked closely. Cycle
the steering from full turn to full turn to check for clearance. Failure to perform inspections may result in component
failure.
3. Re torque all fasteners after 500 miles. Visually inspect components and re torque fasteners during routine vehicle
service.
17. Install the supplied sleeves in the sway bar link bushings
and install on the sway bar and the axle with the supplied
12mm x 65mm bolts and lock nuts.
NOTE: The washer will
install on the upper sway bar link as shown on the head
of the bolt. See Photo 13. Tighten using a 18mm & 19mm
wrench.
18. Repeat steps 3-16 on opposite side of vehicle.
19. Install the wheels / tires. Jack up the vehicle and remove
the jack stands. Lower the vehicle to the floor and torque all
bolts to factory specifications including upper control arms
20. After the vehicle has been lowered to the ground and using
17 mm wrench, reinstall sway bar links using factory
hardware. Torque to factory specs.
Photo 13
KIT CONTENTS