Rough Country 1141 - Manual

REAR COIL SPRING ANGLE CORRECTION KIT
FOR TJ JEEP
92114100
Thank you for choosing Rough Country for your suspension needs.
Rough Country recommends a certified technician installs this system. In addition to these instructions, professional
knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to
install this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the
vehicle.
Please read all the instructions before beginning the installation. Check the kit hardware against the kit contents. Be
sure you have all the needed parts and understand where they go. Also please review the tools needed list and
make sure you have needed tools. If you have any questions please call us at 800-222-7023.
PRODUCT USE INFORMATION
This kit is used to correct the angle of the rear coil spring of the Jeep TJ. The angle of the coil spring on larger lift kits,
generally 6” needs to be realigned with the frame mount to allow the coil spring to function correctly, thus improving
ride and movement.
Do not add, alter, or fabricate any factory or after-market parts which increase vehicle height over the intended height
of the Rough Country product purchased. Mixing component brands, lifts, voids all warranties. Rough Country makes
no claims regarding lifting devices and excludes any and all implied claims. We will not be responsible for any prod-
uct that is altered.
NOTICE TO DEALER AND VECHICLE OWNER
Any vehicle equipped with any Rough country product must have the “Warning to Driver” decal installed on the sun
visor or dash. The decal is to act as a constant reminder for whoever is operating the vehicle of its unique handling
characteristics. INSTALLING DEALER—It is your responsibility to install the warning decal and to forward these in-
stallation instructions on to the vehicle owner for review and to be kept in the vehicle for its service life.
TOOLS NEEDED:
Floor Jack
Jack Stands
13/32” Drill Bit
Drill Motor
9/16” Socket
9/16” Wrench
Coil Compressor KIT CONTENT
2-Rear Angle Correction Spacers
1-1141Bag Containing:
2-3/8” x 1 1/4” Bolts
4-3/8” Flat Washers
2-3/8” Lock Nuts