Rough Country 297N2 - Manual (Page 8)

PHOTO 23
PHOTO 24
39. Install brake caliper / bracket on knuckle using factory hardware with 21mm socket.
40. Install the supplied sway bar bracket on the lower control arm and sway bar as shown with the supplied 12mm x
35mm bolts. Tighten using a 18mm & 19mm wrench. See Photo 24
41. Install the sway bar link in the sway bar bracket and lower control arm bracket using the supplied 12mm x 65mm
bolts and flange locking nuts. Tighten using an 18mm & 19mm wrench. See Photo 25 & 26 T
The bolt will need to be installed as shown with the threads pointing forward.
42. Reinstall the ABS sensor wire and brake line bracket using factory hardware to the knuckle and the upper control
arm as shown in Photo 27.
43. If installing lift on a 2500HD diesel equipped vehicle; Install the new radiator hose support bracket as shown in
Photo 28 with the supplied 1/2” self threading bolt in 1297BAG2 with a 3/4” wrench in the factory hole on the factory
PHOTO 27 PHOTO 28
37. Locate the shaft spacers supplied with kit and install between the stock half shaft and the differential as shown
in Photo 23. Apply thread locker to supplied 10mm x 65mm socket head cap screws in 1297BAG2 and tighten hard
ware.
38. Install the factory axle nut in the knuckle using a 35mm socket and reinstall factory dust covers. Tighten nut to fac-
tory specifications.
FOR USE WITH DIESEL EQUIPPED 2500HD ONLY
Photo 26 Photo 25