Rough Country 263.22 - Manual (Page 6)

25. The brake shroud must be trimmed to allow the caliper to reinstalled, Mark the dust shroud as shown in Photo 18 and
trim. Reinstall the brake caliper on the knuckle with the factory hardware and tighten.
26. On the factory knuckles, remove the bearing assembly using a 15mm wrench and install in the new knuckle. Tighten
hardware. See Photo 19.
27. Install the knuckles on the lower ball joint with the factory hardware. Tighten using a 18mm wrench.
28. Trim tie rod ends as per instructions on last page and install on the knuckle. Tighten using a 21mm wrench.
29. Install the sway bar drop brackets with the 10mm x 35mm bolts, lock washers, and flat washers using a 17mm wrench.
Tighten hardware. See Photo 20.
30. Install the sway bar on the sway bar drop brackets with the stock bolts and supplied 10mm nuts & washers. Tighten
using a 17mm wrench. See Photo 21.
31. Using the supplied template on last page of instructions as a guide, mark and drill the lower control arm using a 11/16”
drill bit to relocate the sway bar end link. See Photo 22. After drilling, install the sway bar end link with the stock
hardware and tighten.
32. Remove the brake line bracket from the upper control arm mount as shown in Photo 23 using a 13mm wrench.
Photo 18 Photo 19
Photo 21 Photo 20
Photo 22 Photo 23
DRIVER SIDE SHOWN