Rough Country 263.22 - Manual (Page 5)

Cut here
Photo 13
16. Remove the four rear cross member bolts and remove the rear cross member brace as shown in Photo 12 using a
18mm wrench.
17. Trim the lower control arm mount on the frame as shown in Photo 13. Trim only enough to allow for installation of new
front RCX cross member.
18. Install the front cross member as shown in Photo 14 with the supplied 5/8” x 4 1/2” bolts, nuts /washers. Do not tighten
at this time.
19. Install the rear cross member in the factory location using the supplied 5/8” x 5 1/2’ bolts, nuts/ washers as shown in
Photo 15.
20. Reinstall the lower control arms in the cross member brackets with the factory hardware. Do not tighten at this time.
21. Install the supplied 3/8” studs on the strut spacer using 9/16” wrench & 3/8” nuts to lock the stud in place. See Photo
16. The stud should clinch with about 35-45 ft/lbs of torque. Do not over torque the nut.
22. Install the strut spacer on top of the strut as shown in Photo 17 with the stock hardware. Tighten using a 18mm wrench.
23. Install the strut in the upper strut tower using the supplied 3/8” nuts, washers & lock washers. Tighten using a 9/16”
wrench.
24. Install the lower part of the strut in the factory location on the lower control arm with the supplied 10mm x 55mm bolts,
nuts /washers. Tighten using a 17mm wrench.
Photo 12
Photo 14 Photo 15
Photo 17 Photo 16