Rough Country 282 - Manual (Page 13)

18. Remove the brake line from the brake line bracket using a 1/2” wrench. See Photo 13.
19. Install the new brake line bracket as shown in the stock location on the differential with stock hardware using a 13mm
wrench. See Photo 14.
20. Install the brake line on the new brake line extension bracket as shown in Photo 15 with supplied 5/16” x 1 1/4” bolt,
washer & nut.
21. Swing the sway bar up and install the supplied rear links as shown in Photo 16 with supplied 1/2” x 2 1/2” bolts/washers
& nuts in lower mount and stock hardware in upper mounts. Tighten to 57 ft. lbs.
22. Install the wheels and tires.
23. Jack up the vehicle and remove the jack stands. Lower the vehicle to the ground.
24. Install the stock shocks in the new mounts with the stock hardware using a 21mm wrench. Tighten to factory
specifications.
BUMPSTOP MODIFICATION
1. Remove the bump stop from the stock location on the frame . Trim the bump stop as shown in Photo 17 using a recip-
rocating saw. This bump stop modification is only on certain models with 4 ring bump stops.
2. Only the top portion will be trimmed as shown in Photo 18. After the bump stop has been trimmed, reinstall on the vehi-
cle in the stock location.
Photo 13 Photo 14
Photo 15 Photo 16
Photo 17 Photo 18