VANCO VPW-280709 (8X8) - Manual (Page 5)

www.vanco1.com
888.769.4156 5
BACK PANEL
1. IR extension
2. DIP switch setting
3. IR emitter, corresponding to the Input port from
1 to 8
4. RS-485 port
5. LAN port
6. RS-232 port
7. Power input
8. Input ports 1 to 8
9. Output 1 to 8 with HDMI and Cat5e/Cat 6
10. ISP Port
NOTE: RS-232 port and LAN port are for matrix
control. The LAN port is connected to the computer
via cross-over UTP and connected to the router or
switcher via direct UTP.
CONNECT AND OPERATE
1. Connect the HDMI input sources
2. Connect the standard HDMI outputs
3. Connect two Cat5e cables to both the STP/UTP
outputs of the Matrix and inputs of STP/UTP
receivers. The cable termination must follow the
standard of EIA/TIA 568B, if used in Single UTP
mode, just connect CAT5E -2).
4. Connect the HDMI output into the STP /UTP
receiver
5. Connect the IR RX receiving cable into STP/UTP
receiver IR RX and connect the IR TX cable into
matrix 9 IR emitter
6. Power on the input source you want to show.
Keep the unused input power off, otherwise it
may interfere with the normal display
7. Connect the power supply into the matrix
8. Turn on the power, when the LED panel stops
flashing circularly, the initialization of the matrix
is ready
9. Turn on the displays you want to watch
10. Use the remote supplied or push the button on
the front panel to choose input source, or using
infrared extension receiver, RS-232, RS-485 or
LAN port to do the control.