VANCO VPW-280709 (8X8) - Manual (Page 15)

www.vanco1.com
888.769.4156 15
DIP SWITCH SETTINGS
Position ID
1 2 3 4 Functions
0 1 0 0 Dual
UTP, EDID COPY
0 1 0 1 Single UTP, EDID COPY
0 1 1 0 Dual UTP, EDID COPY (compatible)
0 1 1 1 Single UTP, EDID COPY (compatible)
1 0 0 0 Dual UTP, 1080P stereo
1 0 0 1 Single UTP, 1080P stereo
1 0 1 0 Dual UTP, 1080P 5.1 channel
1 0 1 1 Single UTP, 1080P 5.1 channel
1 1 0 0 Dual UTP, 1080P 7.1 channel
1 1 0 1 Single UTP, 1080P 7.1 channel
1 1 1 0 Dual UTP, 1080i stereo
1 1 1 1 Single UTP, 1080i stereo
Other conditions Dual UTP, EDID COPY (compatible)
1= ON
0= OFF
Note: After Finalizing Dip Switch Settings the unit must be turned off and then on to save the settings.
READING AND RECEIVING EDID DATA FROM DISPLAY
Before perform reading and saving EDID data from display, please make sure which output is the EDID from
and which input is the destination the EDId will be copied to. The detailed procedures are as below:
1. Choose the output port where the EDID will be copied from (Assumed as OUTPUT_N), and input port
where the EDID will be copied to (Assumed as INPUT_N). Control the matrix to connect them.
2. Under 280709’s normal working condition, push ‘ENTER’ and ‘OUTPUT_N’ simultaneously, within two
seconds will see the LEDs lit the character ‘-‘ circularly (Means the EDID COPY is auto running). Just
release the buttons, waiting for the matrix to finish the operation.
3. If the EDID COPY succeeds, then the LED will show MIX OK. Otherwise the Leeds will display MIX FL.
Push the ‘ENTER’ button or wait for 3 seconds. 280709 goes into normal working condition.