Toner Cable 3000 Series Digital C-Band PLL LNB - Manual (Page 2)

Specifications Subject To Change Without Notice Rev 11-10 ©Toner Cable Equipment, Inc.
969 Horsham Road l Horsham, Pennsylvania 19044 USA l Phone: 215-675-2053 Fax: 215-675-7543 l [email protected]
FREQUENCY BANDS AVAILABLE
Typical Service 1000HA 1000HB 1000HC
Input Frequency (GHz) 11.70 to 12.20 12.25 to 12.75 10.95 to 11.70
L.O. Frequency (GHz) 10.75 11.30 10.00
Output Frequency (MHz) 950 to 1450 950 to 1450 950 to 1700
TYPICAL SPECIFICATIONS
Noise Figure 0.7 to 0.9 dB
depending on model number
L.O. Stability ±10 kHz to ±25 kHz
(over temperature excl. offset) (See HS1000 for < 5 kHz
L.O. stability)
Phase Noise -75 dBc/Hz at 1 kHz
(SSB) -80 dBc/Hz at 10 kHz
-95 dBc/Hz at 100 kHz
Input VSWR 2.2 : 1
Output VSWR 2.2 : 1
Conversion Gain 60 dB
Output P1dB 5 dBm
Power Requirements +15 to +24 V supplied through
center conductor of IF cable
Current Drain 200 mA
Input Waveguide WR75
Dimensions 110 (L) x 42 (W) x 42 (H) mm
(4.3 x 1.7 x 1.7 in)
Weight 300 g / 10.6 oz
Temperature Range -40°C to +60°C
1000H Series KU-Band PLL
FREQUENCY BANDS AVAILABLE
Typical Service HS1000A HS1000B HS1000C
Input Frequency (GHz) 11.70 to 12.20 12.25 to 12.75 10.95 to 11.70
L.O. Frequency (GHz) 10.75 11.30 10.00
Output Frequency (MHz) 950 to 1450 950 to 1450 950 to 1700
TYPICAL SPECIFICATIONS
Noise Figure 0.7 to 0.9 dB
L.O. Stability ±5 kHz to ±2 kHz
(after 60 sec )
Phase Noise
-75 dBc/Hz at 1 kHz
(SSB) -80 dBc/Hz at 10 kHz
-95 dBc/Hz at 100 kHz
Input VSWR 2.2 : 1
Output VSWR 2.2 : 1
Conversion Gain 60 dB
Output P1dB 5 dBm
Power Requirements +15 to +24 V supplied through
center conductor of IF cable
Current Drain 200 mA
Input Waveguide WR75
Dimensions 110 (L) x 42 (W) x 42 (H) mm
(4.3 x 1.7 x 1.7 in)
Weight 300 g / 10.6 oz
Temperature Range -40°C to +60°C
1000HS Series KU-Band PLL
C-Band / KU-Band LNB
s