Toner Cable DTA 3050 Adtec Digital Turn Around Router - Manual (Page 2)

Specifications Subject To Change Without Notice Rev 02-12 ©Toner Cable Equipment, Inc.
969 Horsham Road l Horsham, Pennsylvania 19044 USA l Phone: 215-675-2053 Fax: 215-675-7543 l [email protected]
Front Panel
Tactile Raised Keypad Buttons:
Mode, Select, Enter, Escape, Up,
Down,Left, Right
Blue Translucent LCD:
20 character by 2 row
Front Panel Host LEDs:
Power, Alarm, Link, Busy, MPE
Front Panel LEDs :
In: 1 - 10 ASI
Out: Alarm, ASI, SMPTE 310, CA, GigE
ASI Inputs
ASI x 10 (BNC)
188 or 204 Byte mode
SPTS or MPTS
210 Mbps per input
256 PIDs per input
Fill scrubbing on input
Input Modes:
Auto (Remap all services)
Manual (Add/Drop/Remap PID/Services)
Pass (Pass all services as-is)
MHP Injector SI Injector
Redundancy
1+1 Input N + 1, N + 2 Input
ASI x 2 (BNC inputs for auto switch)
No external controller required
Outputs
Gigabit Ethernet
- SPTS over UDP
- MPTS over UDP
Very low jitter
ASI (model is DTA 3050-ASI)
Mirrored (BNC x 3) Byte or Burst Mode
54 Mbs Byte
210 Mbs Burst Jitter less than 150 (nS)
SMPTE-310 (model is DTA 3050-SMPTE-310)
Mirrored (BNC x 2) Byte Mode only
19.39 Mbs fixed
SMPTE-310 option includes ASI
Table Processing
MPEG Tables:
PAT CAT (if CA is enabled) PMT
DVB Tables:
(Add/Drop/Remap DVB Services)
NIT SDT TDT/TOT EIT
ATSC Tables :
(Add/Drop/Remap ATSC Services)
VCT (Cable or Terrestrial) MGT STT
RRT EIT (1-4)
DCII Tables:
(Add/Drop/Remap Digicypher
services DVB/ATSC)
Conditional Access Encryption
DVB-Common Scrambling Algorithm (CSA)
DVB Simulcrypt TS 103 197 v 1.2.1
FIPS 140-2 hardware based random number
generator (RNG)
Approved 3rd Party CA Vendors include:
CSA: Irdeto, Conax, EuroCAS, KeyFly,
Xcrypt
AES: Verimatrix
Host Platform
PowerPC
Adtec optimized Linux Kernel
10/100 Ethernet RJ-45 (Eth 0)
10/100/1000 Ethernet RJ-45 (Eth 1)
Serial Port (RJ-48)
USB 2.0 (2)
IEEE 1394 (Firewire)
N.C. / N.O. Tally Interface
XML Configuration
HTTP, FTP, Telnet, IP Logging, XCP
(Adtec encrypted layer 3 protocol)
Power
70-240 VAC switching power supply
50/60 Hertz
Rated at 94 Watts return nominal usage 20
watts
Physical
19 in. wide, 1.75 in. tall, 16 in. deep,
(483 x 44.5 x 406 mm)
1 Rack Unit
Weight 13lbs.
Environmental
Active cooling (Push pull Fans)
Operating: 0 to +50 degrees C
Storage: -30 to +65 degrees C
Less than 70% RH
Non-Condensing
Specifications
DTA3050
Digital Turn Around Router
Power: 70 – 240 VAC switching power supply; standard 3-pin computer power plug.
GigE: Gigabit Ethernet used for IP Egress
COM2 - Reserved: Reserved for redundancy switching
COM1 - Terminal: Back end serial port for Adtec service technicians
Fast Ethernet: 10/100 base T ethernet used for connecting to control interface
USB 2.0: Reserved for future use.
ASI Inputs (10): Asynchronous Serial Inputs for receiving programming
ASI Redundancy Input: Used to link 2 DTA-3050 units in tandem; one as primary, one as backup.
SMPTE Redundancy Input: Used to link 2 DTA-3050 units in tandem; one as primary, one as backup.
(Optional)
Redundancy Tally: Used to hook up to an external alarm device
ASI Outputs (3): Triple Mirrored ASI Outputs
SMPTE 310 Outputs (2): Optional Mirrored SMPTE Output