Toner Cable 626 Video Distribution Amplifier - Manual (Page 2)

 Toner Cable Equipment, Inc. Specifications Subject To Change Without Notice.
Telephone: Nationwide: Fax: E-mail: Internet:
215-675-2053 800-523-5947 215-675-7543 [email protected] http://www.tonercable.com
The Model 630 4x1 RF Switch provides 4x1 matrix switch-
ing controlled by contact closures to ground. The switch will
respond to a contact closure or a transistor switch to ground
or a compatible logic level. The control inputs are buffered
to eliminate high output current drive requirements of the
controlling device. The 630 can be controlled by Monroe
Electronics program timers, remote controls or CATV Cue
Tone receivers.
SPECIFICATIONS
Isolation: >65 dB @ 750 MHz unused port terminated to
75
Ω
; “F” connectors
Control Inputs: Internally connected to +12 VDC; 10 mA
maximum to ground
Power Requirement: 117 VAC ±10%; 60 Hz,
Power pack output; +12 VDC
Physical: 2.0”H x 3.25”W x 5.50”D
Model 630 4x1 RF Switch
The Model 626 Video Distribution Amplifier is a top qual-
ity unit. It has excellent specifications for a variety of video
applications. The Model 626 performs as an interface,
allowing a single input source of video to be split into four
identical outputs. The Model 626 overcomes line loss,
assures line equalization and adds outputs to equipment
such as character generators.
SPECIFICATIONS
Input: 75
Ω
termination, 1 volt p~p
Outputs: 4 75
Ω
terminated, 1 volt p~p
Bandwidth: ±0.5 dB, 0 to 30 MHz, -3 dB @ 50 MHz
Gain: Fixed
Power Requirements: 117 VAC ±10%; 50/60 Hz
(Other voltages on request)
Physical: 1.5”H x 2.75”W x 5.25”D
Model 626 Video Distribution Amplifier
The Model 629 Stereo A/V Distribution Amplifier is a high
quality stereo audio and video signal distribution amplifier.
With a video bandwidth better than 50 MHz, the 629 is per-
fectly suited for distribution of any composite video signal
such as C.G. signals and VTR program signals. The audio
section of the 629 is designed for superb quality performance
in the areas of isolation and bandwidth. With detachable
screw terminal barrier strips, audio connections are a snap.
SPECIFICATIONS
Input: 1 video, 1 V p~p, 1 stereo audio, 50K
Ω
0 dB
Outputs: 4 video, 1 V p~p @ 75
Ω
,
4 stereo audio @ 600
Ω
, 0 dB nominal
Video Outputs: -3 dB to + 3 dB into 75
Ω
Video Bandwidth: ±0.5 dB 0 to 30 MHz, -3 dB @ 50 MHz
Video Connectors: “F”, 75
Ω
source terminated outputs
Audio Outputs: -3 dB to +3 dB, 600
Ω
balanced
Audio S/N: Better than 70 dB
Audio Bandwidth: 20 Hz to 20 KHz; ±1 dB
Audio Connections: Screw terminals, detachable
Power Requirements: 117 VAC, 60 Hz
Physical: 2.00”H x 4.25”W x 6.50”D
Model 629 Stereo A/V Distribution Amplifier