Toner Cable PONA 2100 Series Erbium Doped Fiber Amplifier - Manual (Page 2)

Specifications Subject To Change Without Notice Rev 10-11 ©Toner Cable Equipment, Inc.
969 Horsham Road l Horsham, Pennsylvania 19044 USA l Phone: 215-675-2053 Fax: 215-675-7543 l [email protected]
OPTICAL / ELECTRICAL CHARACTERISTICS
GENERAL & MECHANICAL SPECIFICATIONS
Notes:
1) Unless stated otherwise, all specifications apply over the full operating temperature and humidity ranges
2) Measurement variations
3) Measured with 8 evenly spread input optical signals @ 25°C,
∑Pin ≈ 0 dBm (Measuring with 1 input optical signal with Pin
≈ 0 dBm and λ ≈ 1550 nm is also possible. (Low Noise Figure options with NF ≤ 4.0/4.5 dB are available for some models)
4) Measured with a swept Probe Signal (Pp), where Pp ≈ 0 dBm @ 25°C
5) Measured with a swept Probe Signal (Pp), and a fixed Tone Signal (Pt) @ ~ 1550 nm; (Pt ≈ Pp+20 dB; Pt + Pp ≈ 0 dBm)
@ 25°C; Gain Flattened Options with ΔG ≤ +/-0.75dB or ΔG ≤ +/-1.0dB are available (for some models)
6) Over polarization and temperature
7) Static and Dynamic Gain Flatness for PONA 2130 can be defined for 1545 nm
≤λ≤1562 nm and by special request only. (Please
contact your Sales Representative)
8) Specific NF and ΔG can be guaranteed at a single specified Input Optical Power Level (Pin = Pt + Pp) different from 0 dBm.
(Please contact your Sales Representative for more information)
PONA 2100 Series
Erbium Doped Fiber Amplifier