Soloist-hd pro, Broadcast decoder, Specifications – Toner Cable Soloist-HD Pro Broadcast Decoder User Manual
Page 2
Specifications Subject To Change Without Notice
Rev 02-12
©Toner Cable Equipment, Inc.
969 Horsham Road
l
Horsham, Pennsylvania 19044 USA
l
Phone: 215-675-2053 Fax: 215-675-7543
l
Transport
ISO13818-1 188 Byte Transport Stream
Sources: GIGE, Hard Drive
Resolutions
Standard Definition (SD): NTSC, PAL
High Definition (HD): 720P 60/50, 1080i 60/50
Decode Up and Down conversion SD to and from HD
Video Aspect Format: Auto, 4x3 or 16x9
Video Interfaces
SDI, SMPTE 259M (SD)
HDSDI, SMPTE 292M (HD)
HDMI with HDCP
Standard Definition (SD) Decode
MPEG 2 SD: MP@ML up to 15 Mbs
MPEG 2 SD: 422P@ML up to 50 Mbs
AVC/H.264: [email protected] up to 10 Mbs
No support for hierarchical B-frames
High Definition (HD) Decode
MPEG 2 HD: MP@HL up to 60 Mbs
AVC/H.264 HD: [email protected] and [email protected] up to 20 Mbs
No support for hierarchical B-frames
Audio Interfaces
SDI Embedded stereo audio pair per SMPTE 272M
(SD) or SMPTE 299M (HD) based on target video
resolution
Analog audio on balanced stereo 5 Pin RST
HDMI
Audio Outputs: simultaneous embedding on HDSDI,
HDMI and Analog balanced output
Audio Decode
Dolby Digital AC-3: Bit rates up to 640kbps. Sample
rates of 32, 44.1 and 48KHz. Multi-channel 5.1
downmix.
MPEG 1 and MPEG 2 Layer I, II and III (MP3) 2.0:
Bit rates up to 448kbps (Layer I), 384kbps
(Layer II) or 320kbps (Layer III).
Sample rates of 16, 22.05, 24, 32, 44.1 and 48KHz.
Single channel, dual channel, joint stereo and
stereo modes.
AAC-LC MPEG-2 and MPEG-4:
Bit rates up to 384kbps.
Sample rates of 7.35, 8, 11.025, 12, 16, 22.05, 24,
32, 44.1 and 48KHz.
Host Platform
Storage: 160GB hard drive
Embedded Linux real time operating system
Power: 70-240 VAC 50-60Hz and 65 Watts
(20 Watts typical)
Size: 1RU rack mount chassis.
19in. wide, 1.75in. high, 10in. deep
Weight: 8 lbs (3.6 Kg)
Environmental:
Active cooling (Fans)
0 to 90 Degrees Fahrenheit
Less than 70% RH
Non-Condensing
Communications and Control
Ethernet 10/100
GIGE
Ethernet Protocols:
HTTP, Telnet, FTP, UDP/RTP, NTP
Serial Communications:
2-RS232 (38400-115,200K, 8, 1 N)
Front Panel
Keypad: Mode, Select, Enter, Escape, Up, Down,
Left, Right
Blue Translucent LCD: (20 characters by 2 rows)
Host Status LEDs: Power, Alarm, Link, Busy, Storage.
Status LEDs: Play, Multicast, Video, Audio, Resolution,
Alarm
Specifications
Soloist-HD Pro
Broadcast Decoder