Velleman CAMIP5N1 User manual - Manual (Page 4)

CAMIP5N1
V. 03 – 10/06/2013 4 ©Velleman nv
4 lens 10 power LED
5 microphone 11 network LED
6 Wi-Fi antenna 12 5V DC input jack (2A)
6. Hardware installation and operation
1. Choose a location for the camera, keeping following guidelines in mind:
o Do not install the camera in locations where extremely high or low temperatures or excessive vibrations
may occur.
o Avoid mounting the camera near high electro-magnetic fields.
o Do not aim the camera at the sun or other extremely bright objects.
2. The camera can be used free standing or in combination with the included mounting bracket. When the
mounting bracket is used, attach it to the wall or ceiling using the 2 included screws. Place the camera on
top and secure it with the centre screw. Determine the desired angle and tighten the joint screws.
3. Connect the antenna [6] to the antenna connector and/or connect a network cable (included) to the 8P8C
(RJ45) jack [9].
Note: it is possible to connect the camera straight to the 8P8C (RJ45) port of a computer. In this case a
crossed cable (not incl.) should be used and network settings must be configured manually.
4. An external microphone (not incl.) can be connected to the audio input [8].
5. When desired, an external speaker system can be connected to the audio output [7].
6. Plug the DC connector of the power adaptor into the 5VDC input jack [12]. Only use the included adaptor
or one with the same specifications.
7. Plug the adaptor into a suitable mains outlet (100~240V AC/50~60Hz).
Notes:

It takes about 30 seconds for the camera to initialise.
 During initialisation the camera will start moving to test the pan/tilt functionality.
 If the image appears out of focus, turn the lens [4] to adjust.
7. Installing the software
To use the camera, you need to install the software IP Camera Tool on your computer.
7.1 Microsoft Windows
Software requirements
To work with the IP Camera Tool, you need a recent version of one of the following browsers:

Internet Explorer (32 bits version only)
 Mozilla Firefox
 Google Chrome
 Safari
 Opera
Note: the functions and layout of the surveillance tool vary depending on the browser you are using. The
images in this manual are from Internet Explorer on Microsoft Windows.
Installing the IP Camera Tool
The package contains a cd-rom with the required software.
1. Insert the cd-rom in the computer and locate the software installer (IPCamSetup.exe).
2. Double-click the installer to launch the installation wizard and go through the steps of the wizard.
If you are using Windows XP, you may need to restart your PC to complete the installation.
3. You will find the shortcut IP Camera tool on your desktop.
7.2 Apple Macintosh
Software requirements
To work with the IP Camera Tool, you need a recent version of one of the following browsers:

Mozilla Firefox
 Google Chrome
 Safari
 Opera
Installing the IP Camera Tool
The package contains a cd-rom with the required software.
1. Locate the IP Camera Tool for Mac on the CD.