Velleman CAMIP5N1 User manual - Manual (Page 15)

CAMIP5N1
V. 03 – 10/06/2013 15 ©Velleman nv
Reset the device to factory settings
Selecting OK will clear the memory and reset the device to factory settings.
All settings will be cleared:

user settings
 mail and FTP settings
 alarm schedule
 …
Tip: backup the system configuration before resetting your device to factory settings.
11.20 Reboot Device
Reboot the camera

Select OK to reboot the camera.
This will reset the system time.
You can adjust date and time in the Date&Time settings page.
11.21 Log
The log contains an overview of everyone who accessed the IP camera. The log is cleared if the camera is
rebooted.
12. Additional information
12.1 Password
The default administrator login is admin without a password. To enhance security, a new administrator
password should be set as soon as possible (see above).
If you have lost the administrator password, you can reset the camera to factory defaults (admin, no
password) by pressing and holding the RESET button at the bottom of the camera for about 5 seconds.
When doings so, all other user settings will be lost as well.