Velleman HAA2801 - Manual (Page 9)

9
Example – Change of the Link-up Code ( The Master Code of the Master Keypad)
a) Put the Link-up Jumper of the Decoder from OFF to ON
OFF ON
b) Set the Master Keypad to Programming Mode
EXISTING MASTER CODE
* *
c) Set a New Master Code to the Master Keypad
NEW MASTER CODE #
d) Set the Master Keypad to exit from Programming Mode
* *
e) The Link-up in the system is done automatically
BEEP BEEP ----- From Keypad
f) Put the Jumper back to OFF
ON OFF
g) The system is in Split-decoded operation with the new Link-up Code
THE FUNCTION MODE JUMPER -- (AVAILABLE ON HAA2800 ONLY)
Three positions are available for the Function Mode Jumper. Position 1 is for Split-decoded Mode and
the positions 2 & 3 are for Stand Alone Modes.
POSITION 1 – SPLIT-DECODER (MAINS LED LAMP FLASHING)
Position 1 is for Split-decoder mode. All the functions and the 3 output relay operation manners follow
the programmed settings in the Master keypad. All the functions of the decoder are programmable
from the keypad unit. The HAA2800 system is controlled by the keypads and the remote control keys
in the Split-decoded mode.
POSITION 2 – STAND ALONE MODE 1 – START / STOP FOR OUTPUT 1 (MAINS LED LAMP ON)
Position 2 is one of the settings for Stand Alone mode. All the three Output Relays are controlled by
the RF Remote Key with the following functions:
Output 1 – Start / Stop –
Output 2 – Start / Stop –
Output 3 – Manual Momentary –
POSITION 3 – STAND ALONE MODE 2 – ADJUSTABLE TIMER FOR OUTPUT 1 (MAINS LED
LAMP ON)
Position 3 is one of the settings for Stand Alone mode. All the three Output Relays are controlled by
the RF Remote Key with the following functions:
Output 1 – Adjustable Timer –
Output 2 – Start / Stop –––––––
Output 3 – Manual Momentary –
Controlled by Channel 1 of the RF remote key. Press the Button A once to
start and press the button once again to stop.
Controlled by Channel 2 of the RF remote key. Press the Button B once to
start and press the button once again to stop.
Controlled by Channel 3 of the RF remote key. The output relay
operates (Starts) as long as the Button C is pressed and it stops
when the button is released.
Controlled by Channel 1 of the RF remote key. Press the Button A
once to start the timer and it resets automatically after time out. It is
adjustable 1-30 seconds. It is convenient for setting the time for door
strike. Turn the timer clockwise for maximum time. See Figure 2.
Controlled by Channel 2 of the RF remote key. Press the Button B
once to start and press the button once again to stop.
Controlled by Channel 3 of the RF remote key. The output relay
operates (Starts) as long as the Button C on the remote key is
pressed and it stops when the button is released.