Velleman HAA2801 User Manual

Page 31

Example 3: Delete a “Visitor Code” from Vistor ID

in the memory

02 #

(a) (b) (c)

(a) Visitor Code Programming, (b) The Visitor ID, (c) Delete Confirmation

Example 4: Clear all “Visitor Codes” from Location

0999 #

(a) (b) (c)

(a) Visitor Code Location, (b) The Deletion Command Code, (c) Confirmation, all Visitor Codes are cleared

DURESS CODES (FOR OUTPUTS 1, 2 & 3) (Location 41, 42 & 43)

The Duress Codes are prepared for those

Important Persons in case of DURESS while he operates

the access control keypad. The duress code operates like a normal User PIN for Output 1, 2 or 3, and

at the same time activates the Duress Output without any indication. The user may use it to report an

emergency and ask for help silently when he is forced to operate the keypad if the Duress Output is

connected with a security system.
NOTE: The Duress Codes are always valid. They are not governed by any inhibit or lock-out function

in the system.

OUTPUT LOCATIONS

– Duress Codes for Output 1

– Duress Codes for Output 2

– Duress Codes for Output 3

DURESS CODE IDs
ID

50 Duress Codes Are Allowed for The Output 1

10 Duress Codes Are Allowed for The Output 2

10 Duress Codes Are Allowed for The Output 3

0999

Clear all the Duress Codes from the selected Location group.

Please see the programming example below for the details.

THE DURESS CODES
50, 10 and 10 Duress Codes can be programmed for Output 1, 2 and 3 respectively. They are stored

in their two-digit Code ID box. When a new Code is put into the same Code ID box, the old code is

replaced.

The Duress Codes are 4-8 digits for Manual Mode code entry.
The Duress Codes MUST be in the same digit length with the Master Code for Auto Mode code

entry.
Always set a Duress Code that is easy to remember in

Panic Situation. Only one number different

from the daily used User PIN is highly recommended.
Example: User PIN is 1 3 6 9, then 3 3 6 9 or 1 3 6 0 might be a good choice for the Duress Code.

The

Duress Code can also be used to replace the Secondary User PIN or Common User PIN in

Card reading for the Duress reporting.

EXAMPLES:
Example 1: Set a “Duress Code” with the number of “3 3 6 9” for Output 1

3369

(a) (b) (c) (d)
(a) Duress Code Programming for Output 1, (b) Duress Code ID, (c) The Duress Code, (e) Entry

Confirmation

43 01

4-8 DIGITS

DURESS CODE VALIDATION

LOCATIONS

CODE ID

INDIVIDUAL