Velleman HAA2801 - Manual (Page 25)

Example:
User Name Location Function Code User ID PIN/Code Card # Remark
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
--
1,000
RECORD A MASTER CODE --For Both Master & Slave Keypads (Location 01)
MASTER CODE
Master Code is the authorization code for setting the system to programming mode. It is NOT an
User Code operating of the output relays.
The Master Code can be 4 to 8 digits. Press # key to confirm code entry
When a new master code is keyed in and confirmed, the old master code is replaced automatically.
The master code is also the Link-up Code between the keypad and the controller of the system
in Split-decoded operation. Master and Slave Keypads are required to set with the same Master
Code.
Example: Set a Master Code with the number of “2 2 3 3” ----
RECORD A SUPER USER PIN (Location 02)
The Super User PIN has TWO functions. It is prepared for the owner to simply use only one User PIN
to operate the three outputs of the keypad and make operation inhibit enable / disable to the system
outputs.
SUPER USER PIN
The Super User PIN can be 4 to 8 digits.
Two beeps will be heard after pressing the # key to confirm code entry.
When a new Super User PIN is keyed in and confirmed, the old one is replaced.
Example: Set a Super User PIN with the number of “2 5 8 0” ----
To deleted a Super User PIN from memory: Key in just the Location number and #. ----
4 to 8 Digits
SUPER USER PIN VALIDATION LOCATION
02
02 2580 #
02 #
#
4 to 8 Digits
MASTER CODE VALIDATION LOCATION
01
01 2233 #
#
25
INDIVIDUAL
INDIVIDUAL