Trek 152-1 Resistance Meter - Manual (Page 2)

Probes/Accessories (cont) Performance
Features
Test Probes/Accessories
Model 152P-2P Two Point Measurement Range
3 13 Resistance Probe
10 to 10
Performs measurements on surface
areas too small to be measured
with conventional probes.
Model 152P-CR-1 Surface/Volume
Concentric Ring Probe*
Measures surface and volume
resistance of materials as per
IEC or ESDA standards. A three (3)
position switch on the probe selects
either SURFACE resistance or
VOLUME resistance measurements
with either a GUARDED or
UNGUARDED outer electrode. Uses
an exclusive built-in pre-amplifier
design.
IEC 61340-2-3 Electrostatics Part
Resistance Probes, 3mm x 25.4mm
2 and 3
Set of two miniature probes
STM2.1 Garments.
[ Model 152AP-3mm x 25.4mm
S4.1 Work surfaces -
Resistance Probe (pair)] can be
resistive
handheld and randomly positioned.
characterization.
Test Plate Set S7.1 F looring materials.
(consists of two separate plates) STM9.1 Footwear resistive
The use of these plates is described characteristics.
LCD Display
in the ESD STM11.12 (IEC 61340-2- STM11.11 Surface resistance
Three digits plus two digit exponent
measurements of static 3) standard.
(scientific notation).
dissipative planar Conductive Plate
materials. (5" x 5"/127 mm x 127 mm) A Low Battery Indicator
STM11.12 Measurements for stainless steel conductive plate LCD message for low battery.
volume resistance (with a mini banana plug
Test Voltage Range Indicator (IEC 61340-2-3). connector).
Indicates the test voltage selected, STM12.1 Seating - resistive Insulative Plate
either 10 V or 100 V. measurements. (5.4" x 5.4"/ 137 mm x 137 mm)
STM11.13 Two-point resistance Acts as an insulative surface.
Automatic Shutoff measurement.
Walking Test Adapter Kit If the unit is left idle for longer than STM97.1 Floor materials /
The Walking Test Adapter allows 10 minutes, the unit automatically footwear - resistance
analysis of resistance levels on the turns off. measurements in
human body [STM 97.1].
combination with active
user.
Model 152BP-5P Test Probes
2.27 kg (5 lb) (set of two probes)
Available for performing resistance
measurements including
ANSI/ESDSTM4.1 standards (point-
to-point or resistance to ground
measurement)
Battery Operation
Two (2) 9 Volt batteries (NEDA 1604
W.
Alkaline, or equivalent) provide
6 hours of power for portable
Measurement Accuracy (of reading)
operation. at 25 °C ±10 °C and 20% to 70% RH:
AC Line Operation
Point-to-point probes [152BP-5P]
The use of a AC battery eliminator
3 12
10 to 10 W range, ±5%,
allows for AC line operation. The
13
eliminator output connector is a 10 W range, ±8%.
female type 2.1 mm DC power plug.
Concentric Ring Probe [152P-CR-1]
ANSI/ESD Association Standards
and Two-point resistance probe
The Model 152-1 conforms to the
[152P-2P]
following IEC and ANSI/ESD
3 11
10 to 10 W range, ±5 %,
Association Standards for
12 13
measuring surface resistance and 10 to 10 W range, ±10 %.
surface resistivity:
Probe Electrode Test Voltage
User selectable: 10 V or 100 V, ±2%.
Test Current Limit
Limited to less than 13 mA in the
10 V range and less than 1.7 mA in
the 100 V range.
Instrument Dimensions
180 mm H x 100 mm W x 44 mm D
(7² H x 4² W x 1.75² D).
Instrument Weight
Approximately 0.5 kg (1 lb) with
batteries.
*The Model 152-CR-1 will operate with
the previous Model 152 resistivity meter
in “surface” mode, just as the Model
152-CR probe did. The 152-CR will
operate with the Model 152-1
Resistance Meter with the
measurement being in “ohms,” not
“ohms/sq.”
General
Model 152-1 Resistance Meter (cont.)
All specifications are subject to change. 1213/DEC Copyright ã 2012 TREK, INC.
Supplied Accessories · Operator's Manual [23426] · Ground Cord [N9044]
Optional Accessories · Battery Eliminator/Charger (115 V AC) [L5111] · Test Plate Set [17530]
· Universal AC Adapter Kit (90 to 265 V AC) [1K010] · Carrying Case [43378]
· Test Probes purchased separately · Walking Adapter Kit [1K039]
TREK, INC. • 190 Walnut Street • Lockport, NY 14094 • USA • 800-FOR TREK
(fax) • www.trekinc.com • [email protected] 716-438-7555 • 716-201-1804