Milton CAT G3516 1800 rpm 1300 kW 60 Hz Spec Sheet - Manual (Page 3)

C O N T I N U O U S 1 3 0 0 e k W
1 4 0 0 e k W
6 0 H z
TECHNICAL DATA
* *Assumes synchronous driver.
**Emissions data measurements are consistent with those described in EPA CFR 40 Part 89 Subpart D & E and ISO8178-1 for
measuring HC, CO, PM, NOx. Data shown is based on steady state engine operating conditions of 25° C (77° F), 96.28 kPa
(28.43 inches Hg) and fuel having a LHV of 35.6 mJ/N•m
3 (905 Btu/cu.ft) at 101.60 kPa (30.00 inches Hg) absolute and 0° C (32° F).
Not to exceed emission data shown is subject to instrumentation, measurement, facility and engine fuel system adjustments.
LEHE2033-01
3
Generator Set — 1800 rpm/60 Hz/480 Volts DM5498 DM5496
G3516B LE Gas Generator Set
Emission level (NOx) g/bhp-hr 0.5 0.5
Aftercooler — SCAC temperature Deg C Deg F 32 90 54 130
Package Performance
Power rating @ 1.0 pf (unity) ekW 1410 1310
Power rating @ 0.8 pf (3) ekW 1400 1300
kVA 1750 1625
Fuel Consumption (1)
100% load 60 without fan N•m 3 /hr scf/hr 407 15,190 380 14,174
75% load 60 without fan N•m 3 /hr scf/hr 319 11,912 298 11,134
50% load 60 without fan N•m 3 /hr scf/hr 229 8525 211 7879
Electrical Efficiency % 35.3 34.8
Altitude Capability (2)
At 25° C/77° F ambient M ft 553 1813 682 2237
Cooling System
Ambient air temperature Deg C Deg F 25 77 25 77
Jacket water temperature (maximum outlet) Deg C Deg F 92 198 92 198
Exhaust System
Combustion air inlet flow rate N•m 3 /min scfm 115 4290 110 4120
Exhaust stack gas temperature Deg C Deg F 529 985 523 974
Exhaust gas flow rate N•m 3 /min cfm 355 12,525 338 11,923
Exhaust flange size (internal diameter) mm in 203 8 203 8
Heat Balance (2) (3)
Low Heat Value (LHV) fuel input kW Btu/min 4146 235,819 3868 220,033
Heat rejection to jacket water (total) kW Btu/min 826 46,996 798 45,398
Heat rejection to exhaust (LHV to 350° F) kW Btu/min 989 56,262 930 52,907
Heat rejection to A/C — Stage 2 kW Btu/min 193 10,956 133 7542
Heat rejection to atmosphere from engine kW Btu/min 138 7838 137 7794
Heat rejection to atmosphere from generator kW Btu/min 44 2513 43 2432
Alternator
Motor starting capability @ 30% voltage dip* KVA 3271 2661
Frame 824 697
Temperature rise Deg C 105 105
Lube System
Lube oil refill volume w/filter change for standard sump L Gal 401 106 401 106
Emissions**
NOx g/ghp-hr 0.5 0.5
CO g/ghp-hr 2.4 2.5
HC (total) g/ghp-hr 4.8 5.4
HC (non-methane) g/ghp-hr 0.72 0.81
Exhaust O
2
(dry) % 9.1 9.2
Continuous — Output available without varying load for an
unlimited time.
(1) Ratings and fuel consumption are based on ISO3046/1
standard reference conditions of 25° C (77° F) and 100 kPa
(29.61 inches Hg).
(2) Ratings and fuel consumption based on ISO3046/1
conditions with nominal 2.5 kPa inlet restriction and 5 kPa
exhaust restriction. All performance numbers listed on this
page are at these conditions except Fuel input (1) .
(3) Ratings are based on pipeline natural gas having a LHV
(low heat value) of 35.6 mJ/N•m
3 (905 Btu/cu.ft) and 80 MN.
For values in excess of the altitude, temperature, inlet/exhaust
restriction, or for natural gas compositions different from the
conditions listed, contact your local Caterpillar dealer.
RATING DEFINITIONS AND CONDITIONS