Milton CAT C32 1000 kW 1250 kVA 60 Hz 1800 rpm 480 Volts Spec Sheet - Manual (Page 3)

®
STANDBY 1000 ekW 1250 kVA
60 Hz 1800 rpm 480 Volts
SPECIFICATIONS
CAT GENERATOR
SR4B Generator
Frame size......................................................................... 692
Excitation.............................................................Self Excited
Pitch.............................................................................. 0.7143
Number of poles................................................................... 4
Number of bearings............................................................. 2
Number of Leads................................................................ 12
Insulation....................... UL 1446 Recognized Class H with
tropicalization and antiabrasion
IP rating..........................................................Drip Proof IP22
Alignment....................................................... Close Coupled
Overspeed capability - % of rated................................... 150
Wave form....................................................................003.00
Voltage regulator.3 Phase sensing with selectible volts/Hz
Voltage regulation............Less than +/- 1/2% (steady state)
Less than +/- 1% (no load to full load)
Telephone Influence Factor.............................. Less than 50
Harmonic distortion......................................... Less than 5%
CAT DIESEL ENGINE
C32 TA, V-12, 4-stroke watercooled diesel
Bore - mm.............................................. 145.00 mm (5.71 in)
Stroke - mm........................................... 162.00 mm (6.38 in)
Displacement - L................................... 32.10 L (1958.86 in
3
)
Compression ratio........................................................ 15.0:1
Aspiration........................................................................... TA
Fuel system....................................................................MEUI
Governor type..................................................... ADEM™ A4
CAT EMCP 3 SERIES CONTROLS
• EMCP 3.1 (Standard)
• EMCP 3.2 / EMCP 3.3 (Option)
• Single location customer connector point
• True RMS metering, 3-phase
• Controls
- Run / Auto / Stop control
- Speed Adjust
- Voltage Adjust
- Emergency Stop Pushbutton
- Engine cycle crank
• Digital Indication for:
- RPM
- Operating hours
- Oil Pressure
- Coolant temperature
- System DC volts
- L-L volts, L-N volts, phase amps, Hz
- ekW, kVA, kVAR, kW-hr, %kW, PF (EMCP 3.2 / 3.3)
• Shutdowns with common indicating light for:
- Low oil pressure
- High coolant temperature
- Low coolant level
- Overspeed
- Emergency Stop
- Failure to start (overcrank)
• Programmable protective relaying functions: (EMCP 3.2
& 3.3)
- Under and over voltage
- Under and over frequency
- Overcurrent (time and inverse time)
- Reverse power (EMCP 3.3)
• MODBUS isolated data link, RS-485 half duplex (EMCP
3.2 & 3.3)
• Options
- Vandal door
- Local annunciator module
- Remote annunciator module
- Input / Output module
- RTD / Thermocouple Modules
- Monitoring software
September 02 2009 14:28 PM 3
SS-006378.pdf: Secured on 09/03/2009 02:17