Cortech GW CREASEMASTER PLUS 4600 CREASING SYSTEM - Manual (Page 8)

3.2 SELF CENTERING AIR FEED
Side Rail Set-up
• Set single sheet between side rails and bring side rails into meet sheet edges. Check the
sheet slides smoothly between side rails.
• Set Skew on Op Side Rail using graduated marks along slot edges and Skew Adjust Knob.
• Place sheet back in and confirm that it slides smoothly between full length of rails before
tightening the Skew adjust Knob on the Non-Op Side Rail.
• Place Stock in feeder and set front air nozzles (see next section).
• Make sure that any side slots that are in contact with sheet are slightly open (clockwise) and
the rest are closed.
• The Side Rail Air Valves should be started at the first notch open (roughly 2 o’clock position).
Page 8