Cortech GW CREASEMASTER PLUS 4600 CREASING SYSTEM - Manual (Page 18)

CONTINUOUS PERF USING STANDARD ACCESSORY HOLDER
Press the RUN key to start the job running. Pressing the MAIN Key will return
you to the initial programming screen. Press the CNTCLR key to zero the counter
so that the system will count each sheet being perfed. If the machine times out
while the job is running due to lack of paper in the feeder, simply press the RUN
key to resume. Once the job is complete, press the MAIN key to return to the initial
programming screen.
Page 18