Cortech GW CREASEMASTER PLUS 4600 CREASING SYSTEM - Manual (Page 11)

4.1 OPERATING THE TOUCH SCREEN
This is the initial start up screen that appears once the machine is turned on.
Approximately 2 minutes after the screen was last touched, the screen will go into a sleep
mode to conserve power and extend the life of the screen. Touch anywhere on the screen
to make it active again. To begin programming a new job, press the “Program New Job”
key. To run or edit a job that was previously programmed and saved into memory, press
the “Run Existing Job” key and proceed to page 33 for further instructions.
Page 11