Cortech GW CREASEMASTER PLUS 4600 CREASING SYSTEM - Manual (Page 5)

2.0 Machine Assembly
Remove and unpack all machine parts from the shipping carton.
2.1 Power Supply Instructions
Before connecting the power cord to a wall receptacle, make certain the supply voltage is
what the machine has been set up for. The voltage is marked on the sticker containing the
serial number of the machine. If there are any discrepancies, please call your dealer first
before plugging the machine in.
The switch module is located behind the main operator side panel, directly underneath the
infeed. It also houses the main fuse.
Switch Module Location
Fuses
Screw Driver
On/Off
Cord
Receptacle
Steps to Change Fuses
1. Use small screw
driver to pry off
cover
Fuse
Holder
(Red)
2. Remove fuse
holder from module 3. Remove fuse
from module and
replace with 250V
5A Slow Blo 4. Return fuse
holder and replace
cover
Page 5