Altronix AL600UL3 Installation Instructions User Manual
Page 4
- 4 -
AL600UL3/AL600UL3X
Maintenance:
Unit should be tested at least once a year for the proper operation as follows:
Output Voltage Test: Under normal load conditions, the DC output voltage should be checked for proper voltage level
(see Terminal Identification Tables).
Battery Test: Under normal load conditions check that the battery is fully charged, check specified voltage at the
battery terminals and at the board terminals marked [+ BAT -- ] to insure that there is no break in the battery
connection wires.
Note: Maximum charge current under discharge is 0.7 amp.
Note: Expected battery life is 5 years, however it is recommended changing batteries in 4 years or less if necessary.
LED Diagnostics:
AL600ULXB - Power Supply/Charger
Red (DC)
Green (AC) Power Supply Status
ON
ON
Normal operating condition.
ON
OFF
Loss of AC, Stand-by battery supplying power.
OFF
ON
No DC output.
OFF
OFF
Loss of AC. Discharged or no stand-by battery. No Dc output.
Red (Bat)
Battery Status
ON
Normal operating condition.
OFF
Battery fail/low battery.
Terminal Identification:
AL600ULXB - Power Supply/Charger
Terminal Legend Function/Description
L, G, N
115VAC 60 Hz
+ DC –
24VDC @ 6 amp total continuous non power-limited output (supplies power to ALX3B).
AC Fail
NC, C, NO
Indicates loss of AC power, e.g. connect to audible device or alarm panel. Relay normally
energized when AC power is present. Contact rating 1 amp @ 28VDC.
Bat Fail
NC, C, NO
Indicates low battery condition, e.g. no battery presence. Relay normally energized when DC power
is present. Contact rating 1 amp @ 28VDC. Low battery threshold: 24VDC output threshold is set
approximately @ 21VDC
+ BAT –
Stand-by battery connections. Maximum charge current 0.7 amp.
AL3XB - Power Output Module
Terminal Legend Function/Description
-- INPUT +
24VDC from power supply (AL600ULXB)
+ 24VDC --
24VDC @ 3 amp continuous non power-limited output
+ 12VDC --
12VDC @ 1.75 amp continuous power-limited output.
+ 5VDC --
5VDC @ 1.75 amp continuous power-limited output.