Altronix HubWay LD16D Data Sheet - Manual

HubWayLD16D Active UTP Transceiver Hub w/Integral Camera Power trans-
mits UTP video, RS422/RS485 data and power over a single CAT-5 or higher
structured cable. Unit provides 16 camera channels in a space saving 1U EIA 19”
rack mount chassis which may be rack, wall or shelf mounted. Video transmis-
sion range is up to 3000 ft. max. per channel. Units are compatible with AC and/
or DC fixed or PTZ cameras when utilizing Altronix HubWayAv, HubWayDv or
HubWayDvi Video Balun/Combiners. In addition, the unit features individually
selectable 24VAC or 28VAC PTC protected outputs with surge suppression. An
optional HubSat4D Passive UTP Transceiver Hub with Integral Camera Power
can be used as an accessory module to transmit video from up to 4 cameras over a
single CAT-5 or higher structured cable back to the HubWayLD16D. In addition,
the HubSat4D provides power to these cameras locally to eliminate the possibil-
ity of voltage drop associated with long cable runs.
HubWay ® LD16D Active UTP Transceiver Hub
with Integral Camera Power
Rev. DSHubWayLD16D_10312012
Overview
Specifications
UL Listed for Commercial CCTV Equipment (UL 2044).
Agency Approvals
HubWayLD16D
Input:
• 115VAC 50/60Hz, 1.5 amp
or 230VAC 50/60Hz, 1 amp.
• Primary fuse (internal) is rated at 5 amp/250V.
Video:
• Sixteen (16) channels of video over twisted pair
up to a distance of 3000 ft. (914.4m) per channel.
• Eight (8) 75 ohm video outputs.
Data:
• RS422/RS485 data inputs.
Power:
• Individually selectable 24VAC or 28VAC power
outputs with OFF position.
• Unit provides up to 1 amp max. per channel not to
exceed a total of 10 amp (300VA) maximum current.
• Class 2 Rated power limited outputs.
• PTC protected outputs are rated @ 1 amp
per channel.
• Surge suppression.
Visual Indicators:
• AC input power indicator.
• Video signal and power LED indicators.
Features:
• Picture and Gain control.
• Illuminated master power disconnect circuit breaker
with manual reset.
• IEC 320 - 3-wire grounded line cord (detachable).
• Unit can be rack, wall or shelf mounted.
• 1U EIA 19” rack mount chassis.
Accessories:
• Optional HubSat4D allows transmission of up to
four (4) video signals over a single CAT-5 or higher
structured cable.
• Video Balun/Combiners:
- HubWayAv2 - for use with 24VAC cameras.
- HubWayDv - for use with 12VDC cameras.
- HubWayDvi - for use with 12VDC
cameras without isolation.
Mechanical:
• Modular 1U standard EIA 19” rack mount chassis
• Enclosure Dimensions (H x W x D approx.):
1.625” (41.275mm) x 19.125” (486mm)
x
2.498” (63.45mm)
Product weight: 20.85 lbs. (9.46kg)
Shipping weight: 22.15 lbs. (10.05kg)