VEGA VEGAMIP R62 Receiving unit - Transistor - Manual (Page 34)

You can adjust the switching delay with the help of the LED indicating
strip.
Push the two keys (7) and (8) simultaneously for approximately 2 s
until the LED indication flashes.
With the two keys you can select the requested switching delay
according to the following illustration.
The switching delay can be adjusted in seven steps between 100 ms
and 20 s.
200
ms
100
ms
500
ms
1 s 2 s 5 s 20 s
Fig. 36: Adjust switching delay - LED indication flashes
If the indication moves to the right, the switching delay will be longer, to
the left shorter.
The indication returns automatically to the indication of the actual
receive level after approximately 10 s.
If possible, simulate a filling between emitting and receiving unit with
your hand or a metal sheet and check if the switching point is adjusted
correctly. If the control lamp changes its switching status, the switching
function is correct
Switching delay
Simulation
34 VEGAMIP R 62 • - Transistor
6 Setup
41911
-EN
-120228