VEGA VEGAMIP R62 Receiving unit - Transistor - Manual (Page 29)

6 Setup
6 .1 Adjustment elements
The figures in brackets refer to the following illustration.
6
7
9
8
4
5
1
2
3
1
(-) ( )
5 6 7 8
2
+
(-) ( ) +
5 6 7 8
Fig. 24: Electronics module MP6X S receiver unit - Transistor output
1 Mode switch for selecting the switching behaviour (min./max.)
2 Control lamp (LED) for indication of a fault (red)
3 Signal lamp (LED) for indication of the switching status (yellow)
4 Control lamp (LED) for indication of the instrument function (green)
5 Connection terminals
6 Ground terminal
7 Key for adjustment of the sensitivity and the switching delay (-->)
8 Key for adjustment of the sensitivity and the switching delay (<--)
9 LED indicating board for indication of reception strength (yellow)
There are three control lamps (LED) on the electronics module
Control lamp (red) for indication of a fault (2)
This signal lamp shows the fault status of the instrument.
Control lamp (yellow) for indication of the switching condition (3)
The signal lamp signals the switching condition of the switching output.
Control lamp (green) for indication of the instrument function (4)
The green signal lamp (on) shows the operating state of the instrument
as soon as voltage supply is connected correctly.
Signal lamps (2, 3, 4)
VEGAMIP R 62 • - Transistor 29
6 Setup
41911
-
EN
-120228