VEGA VEGAMIP R62 Receiving unit - Transistor - Manual (Page 32)

Press the respective key until the indication is within the LED indication
strip. This means one or two LEDs on the LED indication strip will light
up.
C B A
2 3
1 1 1
Fig. 33: Indication board
1 Indication (LED indication strip)
2 More sensitive - Key to the left
3 Less sensitive - Key to the right
A Medium: Plastics (PP, PVC …), solvents
B Medium: Building material (sand, stones …)
C Medium: Conductive substances (coal, ore, salt …)
Set the indication approximately to the middle of the LED indicating
board until the yellow status indication changes condition.
Depending on the vessel size, process and/or medium, you have to
adjust the sensitivity of VEGAMIP 62 to more or less sensitive. In
products with weak signal damping, in small vessels or pipelines or
with buildup, it might be necessary to test the switching function.
By means of the LED indicating board, you can see the actual
receiving level during adjustment.
When the indication moves to the right, the instrument will be more
insensitive, to the left more sensitive.
In applications with products providing good signal damping (for
example rocks, ore, sand, cement) and where buildup and contam-
ination is expected, you should adjust the instrument to more
insensitive. In this case, the VEGAMIP 62 switches only when there is
a relatively strong signal damping by the medium. Buildup does not
influence the measurement.
In case of buildup, press the key (to the right) until the flashing LEDs
are at the right edge of the LED indicating strip. For strong buildup, you
can press the key several times to make the instrument less sensitive.
The indication of the LED indicating strip does not change, but the
instrument will become a little less sensitive with each pressing of the
key.
Receiving level
Medium provides good
signal damping
32 VEGAMIP R 62 • - Transistor
6 Setup
41911
-EN
-120228