VEGA VEGAPULS 67 (≥ 2.0.0 - ≥ 4.0.0) Modbus and Levelmaster protocol - Manual (Page 43)

43
6 Set up the sensor with the indicating and adjustment module
VEGAPULS 67 • Modbus and Levelmaster protocol
41369-EN-121011
Menu section Menu item Default value
Setup Measurement
loop name
Sensor
Medium Liquid/Water
Bulk solids/Crushed stones, gravel
Applications Storage tank
Silo
Vessel form Vessel bottom, dished boiler end
Vessel top, dished boiler end
Vesell height/
Measuring range
Recommended measuring range, see
"Technical data" in the supplement
Min. adjustment Recommended measuring range, see
"Technical data" in the supplement
Damping 0.0 s
Display Language Like order
Displayed value Distance
Display unit m(d)
Scaling 0.00 %, 0 l
100.00 %, 100 l
Additional adjust-
ments
Distance unit m
Temperature unit °C
Unit SV2
m
Probe length Length of the standpipe Ex factory
Linearisation
curve
Linear
6.5 Saving the parameter adjustment data
We recommended noting the adjusted data, e.g. in this operating
instructions manual, and archiving them afterwards. They are thus
available for multiple use or service purposes.
If the instrument is equipped with an indicating and adjustment
module, the data in the sensor can be saved in the indicating and
adjustment module. The procedure is described in the operating
instructions manual "Indicating and adjustment module" in the menu
item "Copy sensor data". The data remain there permanently even if
the sensor power supply fails.
The following data or settings for adjustment of the indicating and
adjustment module are saved:
•
All data of the menu "Setup" and "Display"
•
In the menu "Additional adjustments" the items "Sensor-specific
units, temperature unit and linearization"
•
The values of the user programmable linearisation curve
The function can also be used to transfer settings from one instru-
ment to another instrument of the same type. If it is necessary to