VEGA VEGABAR 86 HART and accumulator pack - Operating Instructions - Manual (Page 41)

41
8 Diagnosis, asset management and service
VEGABAR 86 • HART and accumulator pack
45040-EN-131107
Code
Text mes-
sage
Cause Rectification
F265
Measurement
function dis-
turbed
– Sensor no longer carries
out a measurement
– Carry out a reset
– Disconnect operating volt-
age briefly
F266
Impermissi-
ble operating
voltage
– Operating voltage below
specified range
– Check electrical connection
– if necessary, increase
operating voltage
The following table shows the error codes and text messages in the
status message "Function check" and provides information on causes
as well as corrective measures.
Code
Text mes-
sage
Cause Rectification
C700
Simulation ac-
tive
– A simulation is active – Finish simulation
– Wait for the automatic end
after 60 mins.
The following table shows the error codes and text messages in the
status message "Out of specification" and provides information on
causes as well as corrective measures.
Code
Text mes-
sage
Cause Rectification
S600
Impermissi-
ble electronics
temperature
– Temperature of the elec-
tronics in the non-specified
section
– Check ambient temperature
– Isolate electronics
– Use instrument with higher
temperature range
S603
Impermissi-
ble operating
voltage
– Operating voltage below
specified range
– Check electrical connection
– if necessary, increase
operating voltage
The following table shows the error codes and text messages in the
status message "Maintenance" and provides information on causes
as well as corrective measures.
Code
Text mes-
sage
Cause Rectification
M500
Error in the
delivery sta-
tus
– Stored delivery status is
incorrect
– Send instrument for repair
Function check
Out of specification
Maintenance