VEGA VEGABAR 86 HART and accumulator pack - Operating Instructions - Manual (Page 23)

23
6 Set up with the display and adjustment module
VEGABAR 86 • HART and accumulator pack
45040-EN-131107
Setup: Settings, e.g., for measurement loop name, application, units,
position correction, adjustment, signal output
Display: Settings, e.g., for language, measured value display, lighting
Diagnosis: Information, e.g. on instrument status, pointer, measure-
ment reliability, simulation
Additional adjustments: PIN, date/time, reset, copy function
Info: Instrument name, hardware and software version, date of manu-
facture, sensor features
Note:
For optimum adjustment of the measurement, the individual submenu
items in the main menu item "Setup" should be selected one after
the other and provided with the correct parameters. If possible, go
through the items in the given sequence.
The procedure is described below.
The following submenu points are available:
The submenu points described below.
In the menu item "Sensor TAG" you edit a twelve digit measurement
loop designation label.
You can enter an unambiguous designation for the sensor, e.g. the
measurement loop name or the tank or product designation. In digital
systems and in the documentation of larger plants, a singular desig-
nation must be entered for exact identification of individual measuring
points.
The available digits comprise:
•
Letters from A … Z
•
Numbers from 0 … 9
•
Special characters +, -, /, -
In this menu item you activate/deactivate the slave for electronic dif-
ferential pressure and select the application.
If you have connected a slave sensor, you confirm this with "Activate".
If you have connected no slave sensor, you confirm this with "Deac-
tivate".
Setup - Measurement
loop name
Setup - Application