VEGA VEGABAR 86 HART and accumulator pack - Operating Instructions - Manual (Page 31)

31
6 Set up with the display and adjustment module
VEGABAR 86 • HART and accumulator pack
45040-EN-131107
With a reset, certain parameter adjustments carried out by the user
are reset.
The following reset functions are available:
Delivery status: Restoring the parameter settings at the time of
shipment from the factory incl. the order-specific settings. A user-pro-
grammable linearization curve as well as the measured value memory
will be deleted.
Basic settings: Resetting the parameter settings incl. special
parameters to the default values of the respective instrument. A pro-
grammed linearization curve as well as the measured value memory
is deleted.
The following table shows the default values of the instrument. De-
pending on the instrument version or application, all menu items may
not be available or some may be differently assigned:
Reset - Setup
Menu item Parameter Default value
Measurement
loop name
Sensor
Application Application pro-
cess pressure
Application level
No reset
Slave for elec-
tronic differential
pressure
No reset
Units Unit of measure-
ment
mbar (with nominal measuring range
≤400 mbar)
bar (with nominal measuring rang-
es ≥1 bar)
Temperature unit °C
Position correc-
tion
0.00 bar
Adjustment Zero/Min. adjust-
ment
0.00 bar
0.00 %
Span/Max. adjust-
ment
Nominal measuring range in bar
100.00 %
Damping Integration time 0.0 s
Additional adjustments
- Reset