VEGA VEGABAR 86 HART and accumulator pack - Operating Instructions - Manual (Page 11)

11
3 Product description
VEGABAR 86 • HART and accumulator pack
45040-EN-131107
You will find additional information in the supplementary instructions
manual "Protective cover" (Document-ID 34296).
Screwed flanges are available in different versions according to the
following standards: DIN 2501, EN 1092-1, BS 10, ANSI B 16.5,
JIS B 2210-1984, GOST 12821-80.
You can find additional information in the supplementary instructions
manual "Flanges according to DIN-EN-ASME-JIS" (Document-ID
31088).
Welded sockets are used to connect the sensors to the process.
You can find further information in the supplementary instructions
"Welded socket VEGABAR series 80" (Document-ID 45082).
The electronics module VEGABAR series 80 is a replacement part
for pressure transmitters of VEGABAR series 80. There is a different
version available for each type of signal output.
You can find further information in the operating instructions "Elec-
tronics module VEGABAR series 80" (Document-ID 45054).
The supplementary electronics "Power pack" is a replacement part for
sensors with integrated accumulator.
You can find further information in the operating instructions "Sup-
plementary electronics for 4 … 20 mA/HART and power pack"
(Document-ID 41033).
Flanges
Welded socket
Electronics module
Supplementary electron-
ics power pack