VEGA VEGABAR 40 HART - Manual (Page 38)

38 VEGABAR 40 (HART ® )
Instrument modification
6 Instrument modification
6.1 Exchange of adjustment
modules
The modular construction of VEGABAR allows
retrofitting, interchange or removal of the
adjustment and display modules. Data previ-
ously saved (e.g. adjustment values) are not
stored in the adjustment module but in an
EEPROM of the sensor electronics and there-
fore readjustment is not necessary. The con-
nection of the modules is made via a 4-pole
plug connection.
Exchange of the adjustment module
Removal of the adjustment module
• Separate VEGABAR from the power
supply.
• Loosen the screws on the upper side of
the housing and remove the cover or the
display module.
• Loosen connection cables from the termi-
nals, if necessary loosen the plug con-
nection of the display module.
• Loosen the two screws of the adjustment
module.
• Remove adjustment module and pull out
plug connection.
Insertion of an adjustment module
• Plug the plug connection of the new ad-
justment module into the plug-in socket of
the sensor electronics.
• Fasten the new adjustment module.
• Reconnect the connection cables, if nec-
essary cable from the display module.
• Close cover or the display module of
VEGABAR.
• Reconnect VEGABAR to power supply.
VEGABAR
Module
without
adjustment Module for
menu-driven
adjustment Module for
basic
functions
Display
module