VEGA VEGABAR 40 HART - Manual (Page 29)

VEGABAR 40 (HART ® ) 29
Setup
Simulation
Pressure can be simulated to check the
outputs of VEGABAR and connected instru-
ments or components. To do this, click to
Diagnosis , then to Simulation .
In the window "Simulation of outputs“ click to
Start to start the simulation. With the buttons
" <– “ and " –> “ (or with the horizontal scroll bar
between) you can adjust values between
-10 % and 110 %. Click to
Stop to end the
simulation.
Note:
The simulation mode is not stopped automati-
cally, but remains active until you switch it off!
Display of measured value
The actual values of the measurement loops
can be displayed from the main menu. Click
to
Display, then to Display of measured
value.
In the window "Display of measured value“
you can choose the unit in which the meas-
ured value is indicated. Furthermore you see
the current value. By clicking to
Quit you
return to the window "VEGA Visual Opera-
ting“.