Vutec SIK232 Interface - Instructions - Manual (Page 9)

9 / 13
In our example from the previous section, we identified systems 12, 13, and 14. So, if
we wanted to close all motors on system 13, we would send the command “*13c00;”
Note:
When sending a command to all systems (such as “*0c00;”), the command will not
4.2. Bus Mode
be
sent to wireless systems. Each system will have to be addressed individually.
When in bus mode, system 7 on the R2D7 operates identically to the other ports.
What else do we need to say about bus mode?