Vutec ELEGANTE MOTORIZED - Installation Instructions - Manual

1
Elegante-Rev H 08/30/2010
INSTALLATION INSTRUCTIONS
Elegante Projection Screen
PLEASE READ THESE IMPORTANT SAFETY INSTRUCTIONS
•
Read and understand all instructions before installing and using.
•
The Elegante Projection Screen meets requirement for fire-resistant and low smoke-producing characteristics .
•
Close supervision is necessary when Projection Screen is used by or near children. Do not leave Screen unattended while
in used.
•
Installer must ensure that the mounting structures and fasteners must be of adequate strength to securely support the
screen so that vibrations or even abusive pulling on the screen surface will not cause the housing to work loose or fall.
•
The Screen Switch is provided with the symbols “O” indicating OFF, “ - ”indicating ON-UP and “ = ” indicating ON-
DOWN.
•
Do not operate Screen with a damage cord or if the Screen has been dropped or damage – until it has been examined by a
qualified serviceman.
•
DO NOT place or attach anything to metal casing or viewing screen.
•
Position cord so that it will not be tripped over, pulled, or contact hot surfaces.
•
DO NOT plug the cord in with wet hands; electric shock could occur
•
DO NOT under any circumstances cut or remove the third (Ground) prong from power cord. For personal safety, this
Projection Screen must be properly grounded.
•
Always unplug Projection Screen from electrical outlet before cleaning and servicing and when not in use. Never Yank
cord to pull cord from outlet. Grasp plug and pull to disconnect.
•
To reduce the risk of electric shock, do not dissemble this Projection Screen, but take it to a qualified serviceman when
service or repair is required. Incorrect reassembly can cause electric shock when Screen is used subsequently,
Cord and Plug Installation Safety Instructions
•
The length of power cord used in this Projection Screen was selected to reduce the hazards of becoming tangled in, or
tripping over a longer cord.
•
We strongly recommend against the use of an extension cord.
•
If an extension cord is necessary, it is absolutely necessary that it is UL-Listed, 3-wire grounding type appliance
extension cord having a grounding type plug and outlet. The electrical rating of the extension cord must be equal or
greater that the rating of the projection screen.
•
Always unplug Projection Screen from electrical outlet before cleaning and servicing and when not in use. Never Yank
cord to pull cord from outlet. Grasp plug and pull to disconnect.
•
Always connect this Projection Screen to a grounded outlet. Outlet–socket should be located near Screen and shall be
easily accessible
“SAVE THESE INSTRUCTIONS”