Vutec ARTSCREEN Surface Hook - Installation Instructions User Manual
Surface mount plasma
VUTEC CORPORATION
www.vutec.com
TEL: (954) 545 9000 - FAX: (954) 545 9011
E-MAIL:
INSTALLATION INSTRUCTIONS
Surface Mount Plasma
Installation
The Plasma must be straight and not tilted for the Art Screen to work properly. Tilting of the Plasma is not recommended.
Referring to Figure 2, use a triangle to determine the Plasma
OD onto the wall. Verify the outline accuracy for a problem
free installation.
Determine the depth of the Plasma – from the wall to the
front bezel surface.
Determine the mounting locations for the wall mount
brackets (Figures 1 & 2). Use proper wall anchors (not
supplied) for drywall installation.
Drill pilot holes for #8 screws or install wall anchors as
required.
Install the Art Screen frame (Figure 3) around the Plasma.
Adjust the Art Screen frame so that it is center around the
Plasma. Tighten the screws.
Adjust the depth of the Art Screen frame so that it is 1/2 to
5/8 (Figure 4) inch more than the depth of the Plasma. This
clearance is required for the Art Screen to travel.
Route the motor wires to the backside for connection later.
Wood Frame Installation
A typical wood frame including the liner is approximately 5
inches wide to properly cover the assembly. The wood
overhangs the main shell approximately 3/4 inch when
attached.
Two corner woods are attached to the backside of the
wood frame to take-up the weight.
The wood frame attaches to the main shell by two
clips on the backside (see Picture Frame Installation
and Removal Section) and hold in place by the ears of
the main shell.
Referring to Figure 6, two side panels are provided for
covering the sides of the Art Screen frame. The panels
apply to the frame by Velcro strips supplied.
The Velcro strips are cut to length. Apply the black
part (Hook) of the Velcro to the sides of the frame.
Apply the white part (Loop) of the Velcro to each of
the panels (Figure 6).
Apply the side panels to the Art Screen frame for a
complete installation. The top and bottom of the Art
Screen frame are left open for proper ventilation for
the plasma.
Optionally, custom-made side panels may be installed
as desired.
Figure
2
Outlining the Plasma OD onto Wall
Figure
1
Rear View of Frame