Vutec SIK232 Interface - Instructions - Manual (Page 12)

12 / 13
7 7 . . A A p p p p e e n n d d i i x x B B : : Q Q u u i i c c k k R R e e f f e e r r e e n n c c e e
7.1. Port Settings
Port Speed 9600 baud
Data Bits 8
Parity None
Stop Bits 1
Flow Control XOn / XOff
7.2. Command Strings
Segment Data Characters
Header * 1
System 1 – 7 for Bus Mode, 1 – 99 for Radio Mode, 0 = “ALL” 1 or 2
Command o, c, s, w, p, a, q 1
Address 01 – 60, 00 = “ALL” 2
Timing (optional) 001 – 999, represents 20 th ’s of a second, 000 = forever 3
Terminator semi-colon “;” or “CR” 1
7.3. Configuration Strings
Segment Data Characters
Header * 1
Command V, B, R 1
Terminator semi-colon “;” or “CR” 1
7.4. Response Strings
Event Response
Power On “version, XOn”
Terminator Received “LF” if good command
“U” if command was not understood
“CR” after command was relayed to controls
Buffer Overflow “O”
Buffer In Empty “XOn” (Ctrl+Q), but only if XOff was sent
Buffer Is Half-Full “XOff” (Ctrl+s)