Vutec LECTRIC I RF - Installation Instructions - Manual

LECTRIC I & III
BUILT-IN RF MOTOR
WALL OR UNDER CEILING MOUNT
The LECTRIC I or III screen may be mounted to the wall or ceiling as shown in Figures 1 and 2 below. The screen
comes with three mounting brackets and screws. Where possible, the mounting brackets should be installed to rigid
structural members. If this is not possible, suitable wall anchors or other mounting methods must be used.
GENERAL
Unless otherwise specified, the motor locates on the left end of the housing. The screen fabric rolls down from the
backside of the roller.
Figure 1
Wall Mounted Ceiling Mounted
Figure 2
Important considerations when deciding the mounting
location for the screen.

The Housing Length (Figure 3) is as follow:
Housing Length = Viewing Width + 10 -¼" (Lectric I)
Housing Length = Viewing Width + 17 -½" (Lectric III)
 The screen is centered in the housing.
 The housing may be moved left or right after it has been
hang for final location.
Determine the housing length and Dim. K. A third mounting
bracket is recommended for middle support for screen of
96 inches viewing width or larger.
INSTALLATION
Dim. K should be approximately 1/6" to 1/8" of Housing
Length.
Install the mounting brackets as required. Be sure they are level
for proper contact with the housing.
Note: If the screen is wall mount, the mounting brackets must be
at least 1-½" inches from the ceiling as shown in Figure 1. If the
screen is ceiling mount, the mounting brackets must be at least
4- ¾" inches from the wall (Figure 2).
Figure 3